Installing firmware on a fresh disk. (Edmini V2)
Connecting the disk
Connect the new disk to a Linux PC. (A windows PC booted from a Linux Live CD or -usb stick is fine). You can use an USB-SATA converter, or connect the disk on an in- or extern SATA port.
You'll need xfstools. Puppy Linux doesn't support xfs
Find device name
Find the device name of the disk:
I'll assume the disk is sdb for the rest of the story.
Download the files here
There are two different sda8 dumps, the original containing fw 1.0.8, and one in which fw 184.108.40.206 is integrated.
You'll need to have root rights to do the next steps. In Ubuntu or Knoppix you can get these by executing
In most other flavors you just execute
Use fdisk to generate this partition table:
Device Boot Start End Blocks Id System /dev/sdb1 1 125 1004031 5 Extended /dev/sdb2 126 30401 243191970 83 Linux /dev/sdb5 1 16 128457 82 Linux swap /dev/sdb6 17 17 8001 83 Linux /dev/sdb7 18 18 8001 83 Linux /dev/sdb8 19 34 128488+ 83 Linux /dev/sdb9 35 125 730926 83 Linux
/dev/sdb2 is the data partition, it uses all remaining space.
/dev/sdb2 is a primary partition, /dev/sdb1 is an extended partition, and all other partitions are logical.
fdisk is started by:
and use 'm' to get further help.
preparing the partitions
mke2fs -j /dev/sdb7 mkdir -p /tmp/mountpoint mount /dev/sdb7 /tmp/mountpoint cd /tmp/mountpoint tar xzf /full/path/to/sda7.tgz cd .. umount /tmp/mountpoint
/dev/sdb8 (ro layer rootfs)
mke2fs -j /dev/sdb8 mount /dev/sdb8 /tmp/mountpoint cd /tmp/mountpoint tar xzf /full/path/to/sda8.tgz cd .. umount /tmp/mountpoint
/dev/sdb9 (rw layer rootfs)
mke2fs -j /dev/sdb9
/dev/sdb2 (data partition)
gzip -cd /full/path/to/sdb6.gz | dd of=/dev/sdb6
When you use 'sudo' commands, this should be
gzip -cd /full/path/to/sdb6.gz | sudo dd of=/dev/sdb6